Automatic Blow Molding Machine in stock 1.Use modular design, reduced the occupation area and it's easy to change spare parts 2.Use the linear type structure, slider hot-pressed and made of the special material 3.The mouth of the annular stainless steel clamping device and integral aluminum alloy cooling device, protect the bottleneck heating deformation, improve the bottle and the bottle cap sealing, prolong the life of the contents 4.The groups of infrared lamp independent thermal balance adjusting device of the bottle blank heating when the temperature uniformity and the bottle exterior color uniform, improve the rate of finished products 5.If you take a blow can debug function of large flow two stage blowing device 6.Adopted photoelectric control pre-blowing and blowing settings, the time is not affected by pressure fluctuations up to the bottle on wall thickness uniformity and consistency ModelUnitAOK-2000 Standar Clamping System锛圢umber of cavity锛?/p>cavities2 锛坈lamping unit锛?/p>KG20000 锛坢old stroke锛?/p>mm130 锛坰tretch stroke锛?/p>mm320 (Bottom stroke)mm30 (Cavity pitch)mm120 (heating pitch)mm55 (Number of holder)PCS64 (Max.container volume)ltr2 (Max. neck diameter)mm32/38 Max.prefrom heightmm140 Max.container diametermm105 Max.container heightmm320 theoretical outputB.P.H2000-2100 Electrical Systemheating ovenUNITS2 box*channel2*9 Number of lamppcs18 heating powerKW21.6 installed powerKW25.5 voltageVoltage220v/380V/3phase Air Systemoperating pressurekg/cm27 blowing pressurempa3.5 high pressure air consumingM3/min2.0 powerKW2.4 Chiller Systemtemperature掳C10-15 pressureMpa0.3-0.5 flow rateL/min40 heating powerHP4 MachineL脳W脳H machine dimensionM2.6*1.8*1.8 (chine weightKG3500Automatic Blow Molding Machine in stock website:http://www.aoktac.net/blowing-machine/automatic-blow-molding-machine/
